How to enable XMP or EXPO for your RAM
New memory runs at a slow default speed until you switch on its XMP (Intel) or EXPO (AMD) profile in the BIOS. It takes two minutes and helps CPU-bound games.
Why it matters
Memory modules store a faster speed profile than the one the motherboard uses by default. XMP (Extreme Memory Profile) is Intel's name for it and EXPO is AMD's; some boards call it A-XMP or DOCP. Until you enable it, the RAM can run well below its rated speed.
Games that depend on the processor, such as Escape from Tarkov, Counter-Strike 2 and Rust, gain the most.
Check your current speed
- Open Task Manager (Ctrl+Shift+Esc) and go to the Performance tab.
- Select Memory and read the "Speed" value.
- Compare it with the speed printed on the memory sticks or in the product listing. If it is lower, the profile is not enabled.
Enable it in the BIOS
- Restart the PC and press the BIOS key while it boots. This is often Del or F2.
- Look for the memory profile option. Boards with an Easy Mode and an Advanced Mode can place it in either. Common names are "XMP", "EXPO", "A-XMP", "DOCP", "AI Overclock Tuner" or "Extreme Memory Profile".
- Choose Profile 1 (or the EXPO profile) when the kit offers several.
- Save and exit (usually F10). The PC restarts, possibly taking a little longer than normal on this boot.
Verify and troubleshoot
- Check the Task Manager memory speed again, or use CPU-Z: the Memory tab shows the current settings and the SPD tab lists the stored XMP/EXPO profiles.
- If the PC will not boot or crashes, clear the CMOS or let the board reset itself, then try again after a BIOS update.
- Make sure all sticks are in the right slots (usually the second and fourth slots from the CPU for two sticks).
One caveat
XMP and EXPO are technically overclocks and not covered by the processor's own warranty, though they are the setting memory makers intend you to use. Do not change anything else in the memory menu unless you know what it does.
Sources: corsair.com, evetech.co.za