Skip to content
Set up my rig

Apex Legends sensitivity settings: mouse and controller guide

Starting values for Apex Legends mouse and controller sensitivity and a way to fine-tune them.

DontLag · · updated Nov 12, 2026

Apex Legends sensitivity settings: mouse and controller guide

For mouse, start at 800 DPI with an in-game sensitivity around 1.4 to 2.0 and an ADS multiplier of 1.0. For controller, use a standard response curve with a modest deadzone and keep aim assist on. These are starting points. Adjust them in small steps.

Mouse settings

SettingStarting point
Mouse DPI800
In-game sensitivity1.4 to 2.0
ADS multiplier1.0 (same as hip-fire)
Full-turn distanceAt 800 DPI and 1.4 to 2.0 in-game, a full turn takes roughly 10 to 15 inches of mouse travel

Apex lets you adjust each scope zoom separately. Keeping them all at 1.0 means the feel is consistent, which is the easiest way to build muscle memory.

Controller settings

  • Response curve: Classic and Linear are the two most common choices. Test one for a few matches before you try the other.
  • Deadzone: A small deadzone is a common choice. Make it smaller if aiming feels sluggish, larger if the view drifts.
  • Look sensitivity: Start from a preset in the middle of the range and change it one step at a time.
  • Aim assist: Leave it on. It helps most at close and medium range.

Finding your setting

  1. Set the starting values and play a few matches.
  2. If you overshoot targets, lower the value by a small step (about 0.1 for mouse, one step for controller).
  3. If you cannot turn quickly enough to track, raise it by the same amount.
  4. Warm up in the Firing Range before ranked.
  5. Stop changing settings once it feels natural.

Controller or mouse?

Controller aim assist is stronger than on mouse, so both are viable. Choose the one that you are most comfortable with. Do not switch mid-season just to follow a trend.

Crosshair and visuals

Choose a crosshair colour and damage feedback that stand out against the map. A clear image also helps when tracking. Lower graphics settings and a stable frame rate help even more than new sensitivity; see our Apex FPS boost page.

Quick tips

  • Write your settings down so you can restore them after an update.
  • Do not copy a streamer's numbers without matching their DPI and screen.
  • Once your aim is steady, learn movement techniques.

Common sensitivity problems

  • You miss to the left or right of a moving target. You are probably over-correcting. Lower sensitivity slightly.
  • You cannot turn around quickly. Your sensitivity is too low. Raise it a little, or practice a larger arm motion.
  • Aim feels different between scopes. Set the multipliers to the same value.
  • The camera drifts on controller. Increase the deadzone.

Mouse hardware

A polling rate of 1000 Hz is fine for most players. Use a mouse pad large enough for a full turn. Turn off mouse acceleration in Windows so your movement is the same each time you swipe.

Testing method

Pick a fixed drill in the Firing Range, for example tracking a moving dummy for one minute. Run it before and after a change. If the result is better, keep the new value. If not, go back. This removes guesswork and is more reliable than remembering how matches felt.

When to change

Change sensitivity only when something clearly feels wrong for several days, not after a single bad session. New seasons sometimes reset or alter settings, so check your values after a major update. Keep a note of the numbers that worked, and treat a new setting as a short experiment with a start date and a review date.

FAQ

Is a lower sensitivity better? Lower values favour precise tracking but need more physical space. Higher values turn faster but are harder to control. The best value is the one you can repeat reliably. Should I use the same settings on every legend? Yes, because consistency is how muscle memory forms. Only change per-scope values if you have a clear reason.

Related guides