Skip to content
Set up my rig

Assetto Corsa Wheel and Force Feedback Settings That Work

Gain near 100, a small minimum force and a short list of effects you can leave off: a clear starting point for Logitech, Thrustmaster and similar wheels in Assetto Corsa.

DontLag · · updated Nov 12, 2026

Assetto Corsa Wheel and Force Feedback Settings That Work

For most wheels, set the driver rotation to the maximum your wheel supports, set Assetto Corsa's force feedback gain to 100 percent, add a small minimum force (5 to 20 percent depending on the wheel) and turn off the extra canned effects. Then tune by feel in a car you know. These are community-tested starting points, not official numbers, and they vary by wheel.

Step 1: set the wheel driver first

Assetto Corsa tells the wheel how far to turn for each car, so the driver should allow the full range.

  • Rotation: the maximum your wheel supports (900 or 1080 degrees). Do not limit it in the driver.
  • Overall strength: around 75 percent is a common start for belt and gear-driven Thrustmaster wheels; adjust to taste.
  • Spring: the game does not use it, so its value does not matter.
  • Damper: the game uses it to add weight when the car is slow or stopped.
  • Boost or similar enhancement features: keep them off.
  • Auto-centre: leave it to the game.

Step 2: in-game force feedback options

These are in Options, Controls, then the advanced force feedback screen.

Driver in a helmet seen in the cockpit of an Audi rally car

Force feedback is what lets you feel the car through the wheel.

SettingStart atWhat it does
Gain100%Overall strength. Lower it only if you feel the wheel hitting its limit in strong corners (clipping).
Filter0%Smooths spikes. Adds delay, so most people leave it off.
Minimum force5% to 20%Lifts the lightest forces above the dead zone of the wheel so you can feel them.
Kerb effectabout 10%A canned vibration over kerbs. At 0 only kerbs that change the car's physics are felt.
Road effect0%Fake road texture. Above about 10% it feels unnatural.
Slip effect0%Vibrates when grip is lost. More distracting than useful for most people.
ABS effectabout 10%Vibration when ABS works. Keep low.
Enhanced understeer effectoffMakes the wheel lighter in understeer; feels artificial.

Which minimum force should you use?

Entry-level wheels with a noticeable dead zone around the centre, such as the Logitech G27, G29 and G920 and the cheaper Thrustmaster wheels, need more minimum force (10 to 20 percent) because the motor does not respond to tiny forces. A stronger Thrustmaster wheel can often do with 5 percent. Direct drive wheels do not have this problem and usually need 0 to 5 percent, but they may need a lower gain, because they can produce much stronger peak forces.

To find the right value: drive slowly through a long, gentle corner. If the wheel feels dead until you steer past a certain point and then suddenly jumps, add a little minimum force. If it jerks around the centre, reduce it.

Check for clipping

If the wheel stays at its maximum force through corners, all detail above that level is lost. In that case lower the gain a few steps rather than the driver strength, until the force just stops reaching the limit in your strongest corner.

Steering settings

Leave gamma, filter and speed sensitivity at their neutral values (gamma 1.00, filter 0, speed sensitivity 0) at first. Changing them hides the real behaviour of the car and makes it harder to learn.

What do popular guides use for specific wheels?

Community guides agree on the basics (gain 100 percent, filter 0, canned effects low) and differ on the details, which is why the table shows ranges, not one number.

WheelDriver rotationMinimum forceNotes
Logitech G29 / G920 / G923900 degrees (native)about 8 to 12%Kerb effect from 10% up to about 30% in some guides; keep road effect low.
Thrustmaster T300 / TX1080 (T300) or 900 (TX)about 5%Overall strength around 75% in the control panel; road effect 0%.
Direct drivewheel maximum0%May need lower gain or lower per-car force because of strong peaks.

How do I check and fix clipping?

Add the Force Feedback app (the in-game FFB meter) to the screen and look for the red bar: it means the signal is clipping. Do not reduce the main gain first. Instead lower the force of that one car (the per-car adjustment on the numpad keys while driving) and keep the main gain at 100 percent. Some cars, especially fast GT3 and prototype cars, clip at high-load corners while a road car on the same settings feels fine.

Does it matter that Assetto Corsa EVO has different menus?

Yes. EVO is a different game with its own force feedback options, so numbers for the original may not apply. The values here are for Assetto Corsa from 2014.

Quick tips

  • Test in a car you already know, for example a road car on a track you know well, and change one setting at a time.
  • Use the assist profile that fits your skill, but turn traction control down gradually once you use a wheel.
  • Controller with a gamepad? Try the pad's default settings first. They are made for it.
  • Mods through Content Manager add more force feedback options. Our mods and Content Manager guide explains the install.

Related guides