Skip to content
Set up my rig
Slay the Spire 2, official artwork

Slay the Spire 2 FPS boost and stutter fix

Work through the settings and the stutter checklist below.

Updated . Game data researched November 2026.

  • Early access
Genre
Roguelike deckbuilder
Developer
Mega Crit
Released
2026
Platforms
PC, Mac, Linux

Upscaling and latency in StS 2

  • Upscaling: not available in this game.
  • Frame generation: not available in this game.
  • Latency: no Reflex or Anti-Lag 2 in this game. Cap your FPS a few frames below your refresh rate instead.

Upscaling explained

How do I fix stuttering in Slay the Spire 2?

StS 2: Fast Mode is not a graphics setting

  1. In StS 2, if the game feels slow, turn on Fast Mode in the game options; it speeds up animations and combat pacing rather than raising fps.

StS 2: Early Access

  1. In StS 2, the game is in Steam Early Access, so performance and options change with updates.

Checklist for every PC

  • Install the game on an SSD: a hard drive causes texture pop-in and hitches. Slay the Spire 2 wants 8 GB of RAM; close browsers and launchers while playing.
  • Lower Textures one step if your graphics card has 8 GB of VRAM or less and you see sudden drops.
  • Let shaders finish compiling on first launch and after driver updates; the first match can stutter.
  • Enable XMP/EXPO so your RAM runs at its rated speed, and update your graphics driver.
  • Check that Windows runs your monitor at its full refresh rate: how to check.
  • Turn on Game Mode and Hardware-accelerated GPU scheduling: Windows gaming settings.

Slay the Spire 2 settings for a low-end PC

SettingLow-end value
Display ModeFullscreen
ResolutionYour monitor's native resolution; scale with the upscaler instead
V SyncOff; use G-Sync or FreeSync with an FPS cap instead
Framerate Limit3 below your refresh rate (141 on 144 Hz); uncapped for max FPS
Particle EffectsLow